Need help? Call us on 01494 461711
5% OFF ALL ORDERS, use the code RR5OFF

Recently added item(s) ×

You have no items in your shopping cart.

FREE DELIVERY & TOOLKIT on orders over £250 - What's this?
50 Year Life Expectancy
Maintenance FREE
BBA Approved - What's this?

Step-by-Step Installation of Rubber Roofing

A typical cold roof installation


Strip off the existing roof back to bare decking or overboard with new ply or OSB.


Remove arris rails from any open edges and fit 2" × 1" timber batten to perimeter.


Lay rubber in the correct position and allow to relax for 20 minutes.


Fold one half of the membrane back and after stirring, roller apply water based adhesive to the deck. Repeat to other half of roof. Sweep out any air bubbles.


Thoroughly stir contact adhesive and thinly apply to both rubber and upstand. Allow to dry then mate together.


Use primer and 9" flashing tape to seal where the roof abuts the building.


Fix RubbaTrim to the roof perimeter c/w matching corners and joiners using the colour coded polynails.


Install wall trim to rear.

Warm Roof Installation

In order to comply with ever changing building regulations, the roof may need to be insulated and turned into a warm roof. The best way to achieve this is by using a foil backed, ply faced insulation board, screwed into the deck. The memberane can then be adhered to the ply face. This option normally means that the perimeter fascias will need to be replaced due to the finished deck height being raised.