Installation
Step by Step GuidesTechno Guides
Laying Membrane Edge Trims Gutter Trim External Edge Corner Wall Trim Flashing Under Tiles Onto Tiles Wall Trim Flashing External Corner (Skylight / Upstand) Internal Corner Pipeseal Seam / Join Rainwater Outlet Horizontal Rainwater OutletLineflex Guides
Lineflex Heat Weld Laying Lineflex Laying Lineflex With Spray Adhesive Laying Lineflex With Mechanical Fixings Edge Trim Gutter Trim External Edge Corner Under Tiles Onto Tiles External Corner Internal Corner Pipe Seal Felt Join Butt Join Rainwater Outlet Horizontal Rainwater Outlet
Laying Lineflex Download PDF
A guide to laying Lineflex Fleece Backed EPDM membrane.
Step 1
The deck must be dry and clean before laying the membrane, position rubber and mark deck as shown 100mm from the edge of the membrane.
Step 2
Roll membrane back and roller apply water-based adhesive to the deck up to the marked line at a rate of 5 litres per 15m2.
Step 3
Mate rubber to the adhesive and sweep out any air bubbles, overlap the next piece of rubber by 50mm. Repeat process.
Step 4
Seal the rubber with a hot air welder using a silicone roller at a rate of 2.5m per minute at 220 degrees (level 4).
