Installation
Step by Step GuidesTechno Guides
Laying Membrane Edge Trims Gutter Trim External Edge Corner Wall Trim Flashing Under Tiles Onto Tiles Wall Trim Flashing External Corner (Skylight / Upstand) Internal Corner Pipeseal Seam / Join Rainwater Outlet Horizontal Rainwater OutletLineflex Guides
Lineflex Heat Weld Laying Lineflex Laying Lineflex With Spray Adhesive Laying Lineflex With Mechanical Fixings Edge Trim Gutter Trim External Edge Corner Under Tiles Onto Tiles External Corner Internal Corner Pipe Seal Felt Join Butt Join Rainwater Outlet Horizontal Rainwater Outlet
Laying Lineflex With Mechanical Fixings Download PDF
A guide to laying Lineflex Fleece Backed EPDM membrane with mechanical fixings.
Step 1
Fix the first section in place using fixings and washers @ 300mm centres.
Step 2
Overlap next section of membrane beyond washers by a minimum of 50mm and seal with hot air welder using a silicone roller at a rate of 2.5m per minute at 220 degrees (level 4).
Step 3
Where applicable, use solvent-based adhesive to adhere to any upstands.
Step 4
Install washers and fixings 40mm from upstand, 300mm apart.
Step 5
Apply primer over the fixings.
Step 6
Seal with 6” cover tape.
